Why Maintenance Matters Less Than You'd Think
Polyaspartic top coats are non-porous, UV-stable, and chemically resistant. That means no sealing, no waxing, and no specialty products. The single biggest threat to your floor isn't chemicals — it's grit. Sand, road salt, and small rocks act like sandpaper underfoot and under tires.
The 5-Minute Weekly Routine
Microfiber dust mop
Removes the abrasive grit before it has time to scratch the top coat.
Walk-off mats at the entry
Stops most debris before it reaches the coating.
Wipe visible spills
Won't damage the floor, but oil and brake fluid get tracked everywhere if left.
Monthly Wet Clean
Warm water + pH-neutral cleaner
Simple Green, mild dish soap, or any neutral floor cleaner. Skip vinegar and citrus-based cleaners.
Soft-bristle deck brush
Never steel wool or abrasive pads. They'll dull the gloss over years.
Squeegee toward the door or drain
Standing water won't hurt the floor but can leave mineral spots in hard-water areas.
Once-A-Year Checks
New cracks in the concrete
Structural cracks can telegraph through. Catch early — easy spot repair.
Edge lift at thresholds
Rare on properly prepped floors, but quick to fix if it happens.
Top-coat dulling in traffic lanes
After 10–15 years, a single refresher coat restores original gloss at a fraction of full install cost.
The Long View
Floors we installed in 2010 are still going strong in 2026 — and the owners did nothing special. They swept, mopped occasionally, and parked their cars. That's it. A good coating system is designed to be lived on, not babied. Use the space the way you want; the floor will hold up.
Related On This Site
Dig deeper into the systems behind a 15-year floor.
- Polyaspartic Floor Coatings
The UV-stable top coat doing the heavy lifting on every project.
- Full Maintenance Guide
Daily, weekly, and annual care in one reference.
- Residential Gallery
See floors years into their service life.